MultiWii WinGUI in control rc setting AUX2 I can not activate arm disarm with yaw.
I use Turnigy 9x and Crius aio pro v2.
is there anyone who can help me?
thanks
arm disarm with yaw
Re: arm disarm with yaw
Is the "#define ALLOW_ARM_DISARM_VIA_TX_YAW" in config.h un-commented?
Did you properly setup the TX's stick end points and center values as seen in the MW GUI???
Both of these are need to arm via stick command.
Did you properly setup the TX's stick end points and center values as seen in the MW GUI???
Both of these are need to arm via stick command.
Re: arm disarm with yaw
geniola wrote:thanks solved!!!
And what did you do to Solve this?????
Re: arm disarm with yaw
in Multiwii winGUI "rc control setting" ARM aux2L, Turnigy CH8 THRO HOLD is not what I wanted but the motors are arming themselves and leave regularly !!
Re: arm disarm with yaw
Just in case anyone else checks this thread with an arming problem, one thing that stopped mine working was not having just the throttle to min and yaw to high.
I had yaw AND roll to min which wont arm it. You have to have only yaw(or roll if you've chosen that in the config.h file) and throttle to high and low respectively. I was so happy i solved it yesterday i made a youtube video going through it if you're still not sure... https://www.youtube.com/watch?v=XKcApDD ... e=youtu.be
Also check that the dont arm when not level is commented out in the config.h file
I had yaw AND roll to min which wont arm it. You have to have only yaw(or roll if you've chosen that in the config.h file) and throttle to high and low respectively. I was so happy i solved it yesterday i made a youtube video going through it if you're still not sure... https://www.youtube.com/watch?v=XKcApDD ... e=youtu.be
Also check that the dont arm when not level is commented out in the config.h file