HK 328p - starting motors?

This forum is dedicated to all issues and questions related to your individual setups and configurations
Post Reply
seikurou
Posts: 14
Joined: Mon Dec 08, 2014 5:37 am

HK 328p - starting motors?

Post by seikurou »

I am using the HK 328p. set the minthrottle to 1064, max to 1864, and mincommand at 1000. Using afros.
When I move the yaw to the right, a blue LED comes on. Does this mean it's armed? motors don't spin. They do when plugged directly to throttle channel and not through FC.
I calibrated the ESCs by plugging the BEC directly to the Rx throttle, Rx turned on and at max throttle, then plugging in the ESC. Turn throttle to minimum and unplug ESC.
Have calibrated acc.
Have calibrated mag.
I can see the sticks moving in the GUI.
Any ideas?

waltr
Posts: 733
Joined: Wed Jan 22, 2014 3:21 pm
Location: Near Philadelphia, Pennsyvania, USA

Re: HK 328p - starting motors?

Post by waltr »

What are the Stick End Point values as seen in the MWconf.exe gui?
Are the stick moving the correct direction?

Winston Churchill
Posts: 1
Joined: Sat Dec 13, 2014 5:09 pm

Re: HK 328p - starting motors?

Post by Winston Churchill »

Try dropping the mincommand to 900, my motors wouldn't start until I dropped it right down.

Can you see it armed in MultiWiiConfig? It should come up green. I use a switch to arm/disarm mine, it feels more in control that way.

Post Reply