For all motors to same throttle for ESC calibration

[stoopkid]

Is there a way to force all four of my motor outputs to directly correspond to the throttle input (not necessarily the actual same PWM, but just corresponding min/max) so that I can calibrate all four ESCs at the same time?

Edit: I went ahead and calibrated each one individually to my controller, then edited the MINTHROTTLE and MAXTHROTTLE to match my controller. Is this a good way to do it? My controller min is about 1055 but I had to go up to 1120 on MINTHROTTLE to get them started. Is that normal? Shouldn't they have been calibrated to start at where my controller was minimum?

[subaru4wd]

Yes the method you used to calibrate your ESCs will work just fine.

The edits you made sound like normal operational procedure.