One motor supplied at 100- 140 more than others?

[Bird]

Hi guys
I have rescripted a couple of times, using the delete function in between but one motor while observing in GUI is always supplied with 100 - 140 more than the others.
Should I replace the ESC or is this a configuration problem?
Any advice appreciated

[Szychor]

I had same problem with my Crius SE. First chceck at GUI is all signals for PITCH,ROLL,YAW is at 1500.If they aren't try to trimm on your TX to 1500 values, and check again motor. Second Thing could be a too much vibrations from motors.

[tovrin]

also, any variances between motors while sitting on the table, with props on or off, should not be too concerning. the copter is constantly trying to correct itself and when its sitting still it can do odd things on the gui.

be more concerned with vibrations you see in the gui while its sitting still, especially with the props off.