Hello.
What could be the cause .. ...
I did this assembly ... http: //electronoobs.com/eng_robotica_tut4_4.php....the incoming signal is PPM combo..ok..At the output of the multiwii board the signals to the servo are correct ... PPM, but the for ESC it is not PPM, it is the one in the image and it does not change depending on the remote control.
Thank you in advance
Sorry for the google translation.
Multiwii is the cause ...?
Re: Multiwii is the cause ...?
did you perform arming? Else motors stay off at mincommand=1000us
Re: Multiwii is the cause ...?
Thanks for the reply.
I made the settings as it says there ..
I tried to carry out the reinforcement .. in many ways..I didn't succeed ...
I have only one engine ... it is stopped at 1000us ..
I made the settings as it says there ..
I tried to carry out the reinforcement .. in many ways..I didn't succeed ...
I have only one engine ... it is stopped at 1000us ..
Re: Multiwii is the cause ...?
I already solved ...
It was from ..Arm ...
When I saw that it was not working from other commands, I checked Aux1 in the middle ... and OK, the engine was working.
The transmitter has only 4 channels, I put 4 more auxiliaries (maybe I have to) and on the Aux1 channel I put a switch with 3 positions ... to test now physically if it arms - disarms.
Google translate...
It was from ..Arm ...
When I saw that it was not working from other commands, I checked Aux1 in the middle ... and OK, the engine was working.
The transmitter has only 4 channels, I put 4 more auxiliaries (maybe I have to) and on the Aux1 channel I put a switch with 3 positions ... to test now physically if it arms - disarms.
Google translate...
Re: Multiwii is the cause ...?
Verified is ... ok.