Page 1 of 1
1000-2000 Range on FlySky
Posted: Sun Aug 14, 2011 8:10 pm
by kvn7500
Anyone have any suggestions on getting this range out of the FlySky 6ch TX? I have changed the endpoints etc. but cant get close to the 1000 or 2000 mark. I sit from about 1180 to 1800.
Re: 1000-2000 Range on FlySky
Posted: Sun Aug 14, 2011 10:03 pm
by captaingeek
increase the throws to 125%
Re: 1000-2000 Range on FlySky
Posted: Sun Aug 14, 2011 11:23 pm
by kvn7500
The maximum endpoint I can specify is 120% and that still doesnt do it.
Re: 1000-2000 Range on FlySky
Posted: Sun Aug 14, 2011 11:43 pm
by mr.rc-cam
I don't own a FlySky, but it seems unusual you cannot achieve more servo range since 1000-2000mS range is a de facto standard in the R/C industry. Are you sure you don't have another mix setting that is interfering? For example, if dual rates (DR) is enabled then it would reduce the available range.
Might be best to check with the supplier. If it is a known issue then beg them for a software upgrade to fix it.
Re: 1000-2000 Range on FlySky
Posted: Sat Nov 12, 2011 10:16 am
by Drifter
I have the same problem . I am using the Spektrum DX5e TX and the Min and Max throws are 1156 - 1904. Can I change the numbers somewhere in the software to allow this range to arm and disarm the motors.
Re: 1000-2000 Range on FlySky
Posted: Sat Nov 12, 2011 6:58 pm
by flyman777
Hello all,
try by changing a little the values underneath seating in MultiWii_xx.pde :
// ******************
// rc functions
// ******************
#define MINCHECK 1100 --> 1200, 1250, ...
#define MAXCHECK 1900 --> 1800, 1750, ...
regards
flyman777
Re: 1000-2000 Range on FlySky
Posted: Sun Nov 13, 2011 3:33 pm
by zviratko
I had the same problem with Hobbyking 6ch tx, range with 127% gain (the most I could specify including a hack allowing me more than 120% of the default config) didn't reach the specified range, had to change it in code..
this should really be put into configuration so people won't have to touch the rest of the code...