Multiwii is the cause ...?

Post Reply
Atmanu
Posts: 4
Joined: Fri Feb 26, 2021 11:18 pm

Multiwii is the cause ...?

Post by Atmanu »

Hello.
What could be the cause .. ...
I did this assembly ... http: //electronoobs.com/eng_robotica_tut4_4.php....the incoming signal is PPM combo..ok..At the output of the multiwii board the signals to the servo are correct ... PPM, but the for ESC it is not PPM, it is the one in the image and it does not change depending on the remote control.
Thank you in advance
Sorry for the google translation.
Attachments
Oscilo.jpg

User avatar
Hamburger
Posts: 2578
Joined: Tue Mar 01, 2011 2:14 pm
Location: air
Contact:

Re: Multiwii is the cause ...?

Post by Hamburger »

did you perform arming? Else motors stay off at mincommand=1000us

Atmanu
Posts: 4
Joined: Fri Feb 26, 2021 11:18 pm

Re: Multiwii is the cause ...?

Post by Atmanu »

Thanks for the reply.
I made the settings as it says there ..
I tried to carry out the reinforcement .. in many ways..I didn't succeed ...
I have only one engine ... it is stopped at 1000us ..

Atmanu
Posts: 4
Joined: Fri Feb 26, 2021 11:18 pm

Re: Multiwii is the cause ...?

Post by Atmanu »

I already solved ...
It was from ..Arm ...
When I saw that it was not working from other commands, I checked Aux1 in the middle ... and OK, the engine was working.
The transmitter has only 4 channels, I put 4 more auxiliaries (maybe I have to) and on the Aux1 channel I put a switch with 3 positions ... to test now physically if it arms - disarms.

Google translate...

Atmanu
Posts: 4
Joined: Fri Feb 26, 2021 11:18 pm

Re: Multiwii is the cause ...?

Post by Atmanu »

Verified is ... ok.

Post Reply