Once connected my multiwii AIO pro board to the PC .
I opened the Multiwii WinGUI (EosBandi) , and while I was planning for a mission, yellow lines appeared on the map screen (see picture below).
They went off with the CLEAR Route button.
But they appeared over and over again.
Is it normal ?
The GPS was fixed and indicating the right home spot location.
Any way to fix this ?
Do these lines prevent the planning for the mission?
Yellow lines on the WinGUI map screen ????
Re: Yellow lines on the WinGUI map screen ????
CopterFLY wrote:Once connected my multiwii AIO pro board to the PC .
I opened the Multiwii WinGUI (EosBandi) , and while I was planning for a mission, yellow lines appeared on the map screen (see picture below).
They went off with the CLEAR Route button.
But they appeared over and over again.
Is it normal ?
The GPS was fixed and indicating the right home spot location.
Any way to fix this ?
Do these lines prevent the planning for the mission?
No. It's not normal at all.
Maybe someone else can figure out how to fix it.
Anybody?
I wouldn't plan a mission on it until you figure things out.
Do you use EZ GUI? If you do, does that happen in mission on the EZ GUI too?
If it did it on both GUI's I would suspect something other than the GUI as the problem.
Do you have the correct magnetic declination entered in your config.h sketch?
Is your ACC and Mag properly calibrated? Are your GPS wires hooked up correctly? Are waypoints enabled? Is the correct GPS type enabled?
(Some things to double check)
If it works ok in EZ GUI I would re-install the program in windows.
Re: Yellow lines on the WinGUI map screen ????
Hello Kbev.
I'm using EosBandi WinGUI on my home PC.
I have doubled checked all the setting you advised.
1 - Correct magnetic declination.
2- ACC and MAG calibrated as usual.
3- My GPS ( U-blox NEO-6) hooked-up as it should.
4- WP enabled.
I'm not using android EZ GUI.
Franky
I'm using EosBandi WinGUI on my home PC.
I have doubled checked all the setting you advised.
1 - Correct magnetic declination.
2- ACC and MAG calibrated as usual.
3- My GPS ( U-blox NEO-6) hooked-up as it should.
4- WP enabled.
I'm not using android EZ GUI.
Franky
Re: Yellow lines on the WinGUI map screen ????
OK solved .
I had a messed up configured GPS module.
I had to reset/erase the config and revert to the factory default.
I started over and now it works perfectly.
Cheers.
Franky
I had a messed up configured GPS module.
I had to reset/erase the config and revert to the factory default.
I started over and now it works perfectly.
Cheers.
Franky