Motors start spinning when hard landing??

Post Reply
Cid156
Posts: 5
Joined: Sat May 14, 2011 3:32 pm

Motors start spinning when hard landing??

Post by Cid156 »

Hello,

I have two problems with my quad

1) When I land too hard (or crashed :roll:), one motor start to spin. I can not stop it even with the command "motor stop". I need to unplug the battery to reset the system. Any idea?

2) My quad is very stable in accro or stable mode. But it is very slow to react to my inputs. I do not use any expo

I use a it3200 and a BMA180

Regards,

Lapino
Posts: 84
Joined: Tue Aug 16, 2011 10:01 am

AW: Motors start spinning when hard landing??

Post by Lapino »

To the second question: maybe your P for roll and pitch is too high...try to lower it a bit and see if it's getting better ;)

Cid156
Posts: 5
Joined: Sat May 14, 2011 3:32 pm

Re: AW: Motors start spinning when hard landing??

Post by Cid156 »

Lapino wrote:To the second question: maybe your P for roll and pitch is too high...try to lower it a bit and see if it's getting better ;)


Thanks that what I am thinking... But the weather is too bad to test :cry:

Post Reply