I have post this on rcgroup without result!:
Hi,I have a fsth9x with dht and trying to use vd5m on my new microquad with crius multiwii se v1
on 2.1 and my receiver channels don't follow where I connect them I must change elev with throt and roll stay on gear no matter what I try
I assign ch1 rud
ch2 ele
ch3 thr
switch ch3 =full ido
ch4 ail
Someone can help?
Thanks
frsky channel not working
Re: frsky channel not working
So multiwii is not comatible with frsky?
Re: frsky channel not working
frsky does work with multiwii (even cppm mode).
am not sure of your question. did you update the firmware on your t9x? how did you set your channel order? why not just reconnect until the gui is happy with the mapping?
am not sure of your question. did you update the firmware on your t9x? how did you set your channel order? why not just reconnect until the gui is happy with the mapping?
frsky channel not working
Are you using a sum signal?
Re: frsky channel not working
I'm using FrSKY D8R-II with MultiWii without problems.
Re: frsky channel not working
Is it possible that the problem come from crius multiwii se v1?