Page 1 of 1
All in one pro USB port...
Posted: Thu Aug 23, 2012 12:49 am
by mummi
So... it broke despite me trying to be careful. should I try to solder it back on? what are my options? I have an usbavr can I use that via the 6 pins under the "AIO PRO" on the board?
Re: All in one pro USB port...
Posted: Thu Aug 23, 2012 9:23 am
by lucamacs
Use a Ftdi USB interface as this one:
http://rctimer.com/index.php?gOo=goods_ ... oductname=Connect it to one of the uart ports of the AIO
Re: All in one pro USB port...
Posted: Thu Aug 23, 2012 10:20 am
by mummi
lucamacs wrote:uart ports of the AIO
Would that be one of the white "serial" ports?
Re: All in one pro USB port...
Posted: Thu Aug 23, 2012 7:33 pm
by TS00
Right hand side, top connector.
Re: All in one pro USB port...
Posted: Thu Aug 23, 2012 7:49 pm
by mummi
TS00 wrote:Right hand side, top connector.
The one next to the "A"?
Re: All in one pro USB port...
Posted: Fri Aug 24, 2012 2:19 am
by chris ables
The one that say's FTDI !
Re: All in one pro USB port...
Posted: Tue Aug 28, 2012 11:18 am
by Pyrofer
Oh Look, the shitty micro-usb port broke off. AGAIN.
This is a serious design flaw with this board, they all seem to be breaking off.
You will be lucky if there are pads left to solder onto, at least 2 of mine lifted completely off so I have nothing to solder onto.
Re: All in one pro USB port...
Posted: Tue Aug 28, 2012 11:40 am
by crashlander
In my case it last quite long but gave in eventually.
Now I'm using FDTI connection.
Maybe hot gluing, before it breaks would help!?
Regards Andrej
Re: All in one pro USB port...
Posted: Wed Aug 29, 2012 1:34 pm
by mummi
Pyrofer wrote:You will be lucky if there are pads left to solder onto, at least 2 of mine lifted completely off so I have nothing to solder onto.
I was lucky..
crashlander wrote:Maybe hot gluing, before it breaks would help!?
That's exactly what I did after the repair
http://dl.dropbox.com/u/65924/Screenshot/Photo%2029.8.2012%2012%2025%2004.jpg
