All in one pro USB port...

[mummi]

So... it broke despite me trying to be careful. should I try to solder it back on? what are my options? I have an usbavr can I use that via the 6 pins under the "AIO PRO" on the board?

[lucamacs]

Use a Ftdi USB interface as this one: http://rctimer.com/index.php?gOo=goods_ ... oductname=
Connect it to one of the uart ports of the AIO

[mummi]

uart ports of the AIO

Would that be one of the white "serial" ports?

[TS00]

Right hand side, top connector.

[mummi]

Right hand side, top connector.

The one next to the "A"?

[chris ables]

The one that say's FTDI !

[Pyrofer]

Oh Look, the shitty micro-usb port broke off. AGAIN.
This is a serious design flaw with this board, they all seem to be breaking off.
You will be lucky if there are pads left to solder onto, at least 2 of mine lifted completely off so I have nothing to solder onto.

[crashlander]

In my case it last quite long but gave in eventually.
Now I'm using FDTI connection.

Maybe hot gluing, before it breaks would help!?

Regards Andrej

[mummi]

You will be lucky if there are pads left to solder onto, at least 2 of mine lifted completely off so I have nothing to solder onto.

I was lucky..

Maybe hot gluing, before it breaks would help!?

That's exactly what I did after the repair

http://dl.dropbox.com/u/65924/Screenshot/Photo%2029.8.2012%2012%2025%2004.jpg