MultiWii

Posted: **Mon Apr 09, 2012 5:48 pm**

Hi, can anybody help please?
I have had to replace 2 of the esc's on my Flydumini . There used to be software available for syncing all the esc's up once installed on the frame. The link was on Pauls site ( Flyduino) but althought the link is still there , the software has been removed.

Any help appreciated as I don't really want to unsolder all the es'c to sort them out.

Shaun

Posted: **Tue Apr 10, 2012 6:22 pm**

I think this is what you are looking for: http://fpv-community.de/wiki/index.php? ... i_anlernen

Posted: **Wed Apr 11, 2012 8:31 pm**

Thanks Arne... that looks like it...

Stupid question time ....Will I have to load 1.8patch 2 software on to impliment this ? Then I can revert to 1.9

Regards,

Shaun

Posted: **Wed Apr 18, 2012 6:23 am**

That's correct.

MultiWii

setting esc's already soldered in position..flydumini

setting esc's already soldered in position..flydumini

Re: setting esc's already soldered in position..flydumini

Re: setting esc's already soldered in position..flydumini

Re: setting esc's already soldered in position..flydumini