Hi,
may be, which is causing all my trouble but i could not explain it for now.
I took pictures and movie to show you what happens. I amplifies a bit the phenomenon but it happens one time on 2 or 3 when i put my plastic canopy. It doesnt happen if i don't put it (you will see in the movie that i could touch everything with my finger without causing a problem). Canopy doesn't touch anything on the board but it is very close to the allinone when it's in place.
The movie to show what is happen :
http://youtu.be/R_ZpgyEvEf8
When it happens, debug 2 increase or decrease a lot (increase in this test), debug 1 seems to stay as it is.
Gyros go crazy during a few second. In the gui, artificial horizon goes crazy and you see the result on gimbal.
After it returns to normal, the gui is like that :
Any idea, static electricity ?
Thks in advance.
A very strange problem...
Re: A very strange problem...
cestb wrote:Any idea, static electricity ?
bad solder joint or exposed wire .. ?
Re: A very strange problem...
That's what i think a the begining but when i touch all solder or wire, i could not reproduce the problem. Only when i approach the canopy which touch nothing...
Re: A very strange problem...
No idea for my pb?
Re: A very strange problem...
Do you have everything connected with common ground?
Otherwise you can get strange glitches.
Otherwise you can get strange glitches.
Re: A very strange problem...
I will verify but i think yes.