Pulsating Motor Jitter when using EZ GUI upon Arming?

Post Reply
fauslyfox110
Posts: 11
Joined: Tue Jan 05, 2016 7:26 am

Pulsating Motor Jitter when using EZ GUI upon Arming?

Post by fauslyfox110 »

I'm running Multiwii se 2.5 on a multiwii 2.5 on my quadcopter. ESCS are properly connected and calibrated, wiring has been checked and heat shrinked, accelerometer and mag calibrated. Below is the link to the board I'm using specifically:

https://www.amazon.com/Hobbypower-Multi ... ltiwii+kit

I have no issue arming it with my receiver, but when I try to use EZ gui I'm getting motor jitter upon arming, the motors cycle on and off as if pulsing. I'm not sure what it might be; this doesn't happen when arming and using the Transmitter. Below is a short video showing the issue. Any ideas?

https://www.youtube.com/watch?v=gDgoiUX0lBQ

Post Reply