I was given the guts of two older racers both with NanoWii boards. I got one running on a Futaba with little trouble. The throttle was reversed and I had to extend the throttle end points but I fixed those issues quickly.
The second I bound to my JR9503. I'm using a DSM2 satellite, bound it with a RX then pluged it into the NanoWii. I soldered the connections properly for that, chose it in the nanowii setup app and its light comes on solid when the TX is on, so it appears to be bound. However, I can't get the motors to arm.
I have set "arm" to the middle and top positions of Aux1 in the MultiWiiConfig program and reassigned Aux1 to the 3 position Flight Mode switch. I have inhibited the throttle hold switch. I have tried all of the positions with the throttle at full in case it is reversed.
Any help would be greatly appreciated. Thanks guys.
1 post • Page 1 of 1