naze32 hexacopter with gimbal and led strip?

Post Reply
blacksky87
Posts: 1
Joined: Wed Mar 23, 2016 2:48 am

naze32 hexacopter with gimbal and led strip?

Post by blacksky87 »

Hello all, so been working on a hex set up, and trying to figure out if it's possible to do what I'm trying to do. After frying one board, I finally got gimbal control from my transmitter, woo! But now, trying to add LEDs to it, but after enabling servo tilt to use the gimbal, all of the esc's are shifted over, which takes up rc pin 5 on the board for the led output. Is there any way to shift rc pin 5 to a different spot? Or is their something obvious I'm missing? Thanks for any input as this has been driving me up a wall.

F550 frame
Naze32
Flysky fs-i6 running ppm

Post Reply