Hello,
i'm new to soldering and electronics in general so bare with me please.
After soldering my pins on the Naze32 the continuity Check Pings between -VBAT Pin and -TELEM Pin.
also I get a Ping between all my Motor GND Pins and same is the case with the Motor + Pins (the Signal Pins are not connected)
did I short anything ? when connecting my Board with the miniUSB it works fine and I can connect with CleanFlight App (all sensors looks good as well as the Calibarations).
Thank you
Continuity Check on Naze32 rev5
-
- Posts: 221
- Joined: Fri Mar 06, 2015 5:44 am
Re: Continuity Check on Naze32 rev5
Between batt- and TELLM- there should be continuity (the TELEM signal is logic high), about the motor pins, are you talking about the positive and negative rails or signal output's or what?