Flip Pro and SBUS

[dfruehwald]

Where do you attach SBUS on a 32u4 based controller?

Can SBUS and Bluetooth be used at the same time?

Can CPPM and Bluetooth be used at the same time?

[Arakon]

CPPM and bluetooth, yes. sbus and bluetooth, no.
You only have one serial port available.

[dfruehwald]

Thanks. In that case I'll get a SBUS to CPPM converter or switch to a D Series receiver which might be a better option so I can have Telemetry.

Is there a board that can do Bluetooth and SBUS at the same time? A Mega or STM perhaps.

[Arakon]

Any atmega2560 based board will do that.. they have 4 serial ports.

[dfruehwald]

Thanks. I found a Pro Mini which is a 2560 in the 50x50 format that should work.

Just have to decide between that or the Quanton (32-bit) boards.

[dfruehwald]

Got my Flip Pro working with S.Bus. You need an inverter cable then connect signal to RX1. I used the Raw input so the onboard reg supply's 5V to the Receiver via VCC and Ground. Had to go to 2.3 - 1648 to get S.Bus values to be stable with FrSky X4R