I have a 2560 based FC and would like to be able to have a bluetooth module connected to serial 1, GPS to serial 2, and an OSD connected to serial 3. The release notes for 2.2 say that it is possible to use all serial ports for a GUI connection. I've went through config.h and I can see how to define a serial port for a GPS and a LCD config module, but nothing about how to use the other serial ports for a GUI type use. I would like to retain serial 0 for programing and USB GUI connection.
So, could someone help?
Nick
How to use Serial Ports 1, 2, 3
-
Nicksdesign
- Posts: 63
- Joined: Sat Jan 26, 2013 6:49 am
Re: How to use Serial Ports 1, 2, 3
I see there is a better place for this question. I'm going to move this to the Getting Started, Config, and Setup forum.
Nick
Nick