Page 1 of 1

multiwii pro board - how connect the gps?

Posted: Thu Apr 04, 2013 11:34 pm
by dubzn1
so finally fixed the servo bur with a different refresh rate
super

so now id like to make use of the gps
as i got it , it has 6 seperate wire and at the front of the board it has 4
can anyone point me in the right direction as to what wires go where?

Re: multiwii pro board - how connect the gps?

Posted: Sat Apr 06, 2013 7:49 pm
by Nicksdesign
Assuming that you are referring to the Hobby King board, or similar: I have this board, but have not yet used it. I would connect the center four wires from the MTK GPS to the like named pins on one of the FC's serial ports. You may, or may not, need to connect tx/rx to tx/rx or tx/rx to rx/tx. Which ever works. (Some boards have them pre-swapped. Tx to RX and Rx to Tx if not pre-swapped.)

Nick

Re: multiwii pro board - how connect the gps?

Posted: Tue Apr 09, 2013 6:52 pm
by QuadBow
dubzn1 wrote:can anyone point me in the right direction as to what wires go where?


I saw different types of gps devices,
with 4 wires, with 6 wires,
with different layouts,
with description, without description,...

So, go and ask the gps vendor for more details...

The same applies for the multiwii pro board. Which are you referring to?