Hi all!
Anyone tryed to connect WMP and NK in direct connexion method ?
Yesterday I tried to do that but without success or middle success...
My WMP alone in direct connexion work like a charm. But with NK on the same wire... arduino's LED blink continuously.
I have wired all components like this picture:
http://wbb.multiwii.com/download/file.php?id=57&mode=view
but with my version of NK:
I hope I have not cut important things !!
On my MultiwiiConf, ACC is present. When I start arduino, ACC_Z increaze and stabilize to ~200. But no others activities :
SCL signal :
SDA signal:
On SDA, voltage level is very bad... 2V contrarily to VDD 2.8V (OK on VDD of WMP and NK)
Software configuration:
#define ITG3200
#define NUNCHACK
#define I2C_SPEED 100000L
#define INTERLEAVING_DELAY 5000
I've tried many combination but without success
May be add other pull-up ? http://wbb.multiwii.com/viewtopic.php?f=6&t=178&start=10#p1591
WMP+NK direct connexion
Re: WMP+NK direct connexion
May be add other pull-up ? http://wbb.multiwii.com/viewtopic.php?f=6&t=178&start=10#p1591
I think i should change my pull-ups resistor value. On my WMP, default pull-up values are 2,2Kohm.
From any electronic site, I read that pull-up can be in the range of 1k to 10k (http://www.i2c-bus.org/how-i2c-hardware-works/)
May be the best way for me is to try with greater pull-up value.
-
- Posts: 2
- Joined: Thu Aug 04, 2011 10:11 pm
Re: WMP+NK direct connexion
Hi !
I get the same NK board as yours too. It work normal from the beginning . But it not work when I cut it to half.
I finally found the answer.
It work again when I connect it as the photo.
Hope it can help.
I get the same NK board as yours too. It work normal from the beginning . But it not work when I cut it to half.
I finally found the answer.
It work again when I connect it as the photo.
Hope it can help.
Re: WMP+NK direct connexion
logitech888 wrote:Hi !
I get the same NK board as yours too. It work normal from the beginning . But it not work when I cut it to half.
I finally found the answer.
It work again when I connect it as the photo.
Hope it can help.
Hi, i´m a new member of this forum and i have NC ver GH0901B-PCB1 (2010-11-18) and see almost the same as yours.
Where you connect the red points of R4?
-
- Posts: 2
- Joined: Thu Aug 04, 2011 10:11 pm
Re: WMP+NK direct connexion
Hi Joe.
Sorry for late reply!
I think this photo will help. Just connect like this.
Sorry for late reply!
I think this photo will help. Just connect like this.
Re: WMP+NK direct connexion
These bridges are for cutting the board?