Hello,
since I changed the PID values in the GUI I have suddenly a problem: when I arm the copter the one motor starts to spin (without increasing throttle) and the GUI shows 1150 by all motorsignals. When I increase throttle all motor spin. And then when I decrease throttle all motors continue spinning and the motor values in GUI are 1150. I resetted the PID setting and have already the same problem. Does anyone know what I can do?
motor spin after arming
Re: motor spin after arming
You need to calibrate the esc's.
Default setting in MWii is that motors spin at idle when it's ARMED.
Uncomment to change it.
#define MOTORSTOP
Default setting in MWii is that motors spin at idle when it's ARMED.
Uncomment to change it.
#define MOTORSTOP