ESC not working properly with transmitter

Post Reply
Flying EEL
Posts: 1
Joined: Thu Dec 31, 2015 3:07 pm

ESC not working properly with transmitter

Post by Flying EEL »

Hi,
I'm building my first drone and seem to having problems with my ESC's! I have a Naze 32 rev6, 4 x Emax Biheli Series 12a ESC's i'm using a Spectrum DX6i with a Orange RX410x satellite receiver. The problem I have is the motors all spin up together in clean flight no problem but when I use the transmitter they don't.
What I get is they all start together then motor 3 spins straight up to 100% and the other 3 stay around 5% and I have only slightly moved the transmitter stick. If I go in to the receiver tab of Cleanflight all the movements look good and move smoothly, I have the Transmitter setup for ACRO with the modulation type as Auto-DSM, DSM-X and DSM-2 standard receivers. In Cleanflight I have configured it as RX-PPM and selected Spectrum 2048.
Any advice would be much appreciated.
Thnaks
Lee

Post Reply