Hello everybody,
I have finish an hexacopter until 2-3 days. I made an ESC calibration with my multiwii. Now when I push the throttle to the maximum, one motor is at 2000 but all other motors have not 2000 but are between 1200 and 1800.
Is it normal ? Is it the ESC calibration not good or need I adjust my PID settings.
I have try to elevate my copter. It's work but I need to have the throttle at 70-80%. Is it normal too ? The problem could be the Settings ?
Thanks.
ESC Calibrations and PID Settings
-
- Posts: 12
- Joined: Thu Jul 23, 2015 8:00 pm
-
- Posts: 234
- Joined: Wed Dec 24, 2014 1:20 am
- Location: ......
Re: ESC Calibrations and PID Settings
.
Last edited by FengShuiDrone on Fri Aug 07, 2015 1:15 am, edited 1 time in total.
-
- Posts: 12
- Joined: Thu Jul 23, 2015 8:00 pm
Re: ESC Calibrations and PID Settings
Like I say on the other post : Ok I will try. But as I see on the web I have an other problem because when I move my throttle command, pitch and roll change too (like in my video). Is it normal ?