FlySky CT6B does not connect to Multiwii 328p V2.5

[Passa2]

Hello, I'll be as short as I can.
I recently bought a Multiwii board, I updated the firmware and connected it to the receiver (R6B), all the esc are plugged in everything is set up in the right way, but the transmitter does not transmit anything at all. Even if i connect it to the GUI all the six channels don't move when I move the control sticks on the transmitter.

I already tried all the preset transmitter strings, and the transmitter works by itself.

I plugged the servos in the receiver in this order: Throttle (that powers up the receiver), Pitch, Roll, Yaw.

I'm a newbie so every suggestion even the most stupid could help me.

Thanks a lot.

Francesco

[waltr]

Did you BIND the RX to the TX as per the CT6B manual?

[LeoTheHuman]

What I found out is that this board with this receiver connected to aux2 channel becomes very unstable and freaks out. Have not checked for a reasons yet, I'm just not connecting channel 6 for the moment.

[waltr]

Use the GUI and check setup the TX's Stick end point values.
Sounds like the AUX2 values are way out and/or it is "mixed" with other functions in the TX.
Ensure the TX mode is set to "acro".

You can connect the RX AUX2 output to another input channel for testing.