STATUS: Crius AIO PRO V2 - MultiWii WinGUI 2.3 PRE 8
I SEE EVERYTHING PERFECTLY ON WinGUI, ACTIVE SENSORS GPS, ACC, BARO, MAG,
THR, PICH, ROLL, YAW CONTROL MEET THE RADIO, AUX 1 ON THREE POSITION SWITCH WITH GEAR.
THE PROBLEM 'THAT ARE IN MOTORS WinGUI THR, Quadcopter X, NOTHING MOVES.
I FEEL A LOT OF POWER-BEEP, BEEP IN RECOVERY CONTINUE.
WHAT CAN I DO TO TURN ON OR MOVE THE MOTORS FROM THE RADIO ???
ACTIVE THE MOTORS
Re: ACTIVE THE MOTORS
Start by reading the MW Beginners thread in the MW setup sub-forum. Then open the links in that thread and study the tutorials.
You probably did not:
1- define the correct FC board in the config.h MW file
2- Did not properly setup the TX's stick end points and center values.
3- thoroughly read how MW works.
FYI: Turn OFF the CAP LOCKS. All capitals posted to a forum means you are SHOUTING!
You probably did not:
1- define the correct FC board in the config.h MW file
2- Did not properly setup the TX's stick end points and center values.
3- thoroughly read how MW works.
FYI: Turn OFF the CAP LOCKS. All capitals posted to a forum means you are SHOUTING!