Page 1 of 1
motor turns slowly
Posted: Mon Sep 22, 2014 4:06 pm
by abacusalanya
hi, I'm new
I make a quadcopter "quadx"
I use
1100 kv motor
25 A esc
multiwii SE v2.5
3s 2200 mah battery
but the motors does not turn fast enough and not flying quadcopter.
please help me
Re: motor turns slowly
Posted: Mon Sep 22, 2014 4:16 pm
by capt
Calibrate you ESC's?
Re: motor turns slowly
Posted: Mon Sep 22, 2014 4:53 pm
by abacusalanya
yes I'm activate the define ESC_CALIB_CANNOT_FLY
Re: motor turns slowly
Posted: Mon Sep 22, 2014 5:44 pm
by capt
You could try to calibrate them by plugging directly into the RX CH3.
RX off
TX on
Throttle full
Plug RX in to power
ESC beeps
Pull Throttle to idle
ESC beeps again
done.
Re: motor turns slowly
Posted: Tue Sep 23, 2014 10:37 am
by abacusalanya
when I connect esc direct rx ch3 motors turn very fastly
Re: motor turns slowly
Posted: Tue Sep 23, 2014 3:54 pm
by waltr
Re-calibrate all the ESCs directly from the RX throttle channel.
Re: motor turns slowly
Posted: Fri Sep 26, 2014 9:01 am
by abacusalanya
waltr wrote:Re-calibrate all the ESCs directly from the RX throttle channel.
How do I make it ?
Re: motor turns slowly
Posted: Sat Sep 27, 2014 3:13 pm
by abacusalanya
DOES NOT fly Vibrates more
Re: motor turns slowly
Posted: Sat Sep 27, 2014 9:37 pm
by waltr
This sounds more like a Bad solder joint between ESC and Motor or a broken wire inside the motor.
OR- very badly out of balance motors or props or both.
Re: motor turns slowly
Posted: Mon Sep 29, 2014 8:36 am
by abacusalanya
waltr wrote:This sounds more like a Bad solder joint between ESC and Motor or a broken wire inside the motor.
OR- very badly out of balance motors or props or both.
when throttle %50 and right stick pull right or left, flipped my quadcopter (left or right motors turns normally)
Re: motor turns slowly
Posted: Tue Sep 30, 2014 11:17 am
by abacusalanya
Is there anyone who can help ?
Re: motor turns slowly
Posted: Tue Sep 30, 2014 2:08 pm
by capt
We need more information. What is the problem?
Screen shot of GUI and config.h might help.
Re: motor turns slowly
Posted: Fri Oct 03, 2014 4:46 pm
by abacusalanya
I've shared a video on youtube . watch the video and help me please
http://youtu.be/zh3OmCTiQsw
Re: motor turns slowly
Posted: Fri Oct 03, 2014 5:18 pm
by abacusalanya
my config.h
Re: motor turns slowly
Posted: Sat Oct 04, 2014 1:33 am
by waltr
Very hard to tell but it looks like the props are on the wrong motor and/or the motors are all turning the wrong way.
Is Green props the front and red the back. If so then recheck the MW Wiki and tutorials plus the beginnre's thread.
Show us a screen shot of Multiwiiconfig.exe with the RX/TX on and the sticks centered to see the center values.
If a video of MWconfig.exe then show the stick end point values.
Re: motor turns slowly
Posted: Tue Oct 07, 2014 8:53 am
by abacusalanya
waltr wrote:Very hard to tell but it looks like the props are on the wrong motor and/or the motors are all turning the wrong way.
Is Green props the front and red the back. If so then recheck the MW Wiki and tutorials plus the beginnre's thread.
Show us a screen shot of Multiwiiconfig.exe with the RX/TX on and the sticks centered to see the center values.
If a video of MWconfig.exe then show the stick end point values.
Pictures of my motor rotation is as follows. And all propellers blows down.
Re: motor turns slowly
Posted: Tue Oct 07, 2014 3:48 pm
by abacusalanya
the problem was solved
I had to replace the whole propellers.
Re: motor turns slowly
Posted: Tue Oct 07, 2014 8:59 pm
by capt
Where the propellers slipping in the hubs?