ESC calibration not working

[Jonny360]

Trying to calibrate some simonk luminere 12a escs. I am using ppm and my RX has no other working ports so I must do my calibration through the multiwii. I have done the define esc calib cannot fly. My escs beep. I disconnect power, reupload my code with define esc calib commented out. But my escs still don't spin together. I am at a loss, any help is appreciated.

[brewski]

Simon K do not require calibration.
Just set Min Throttle for Simon K & don't worry if they don't spin at same rate. All will be OK when flying