hello,
I've just built my first MultiWii quadcopter.
My setup is:
Flight controller: MultiWii PRO Flight Controller w/MTK GPS Module
ESC: Hobby King 30A ESC 3A UBEC
Motors: D2830-11 1000kv Brushless Motor
Battery: Turnigy 3300mAh 3S 30C Lipo Pack
Props: 8045 SF Props 2pc CW 2 pc CCW Rotation
I have everything connected and uploaded the multiwii 2.3 software to the multiwii pro board.
When I connect the battery ther are 5 tunes and the leds are flashing but when I want to arm the motors, nothing happens. I tried everything but they wont work.
Is there anyone who could help me?
Greets,
Mathies
motors dont run on multiwii quadcopter
-
- Posts: 2
- Joined: Wed Jul 23, 2014 1:18 am
Re: motors dont run on multiwii quadcopter
check if the yaw middlepoint are at 1500 if not trim the tx
and also did u define allow arm disarm via tx yaw
and also did u define allow arm disarm via tx yaw
Re: motors dont run on multiwii quadcopter
The yaw middlepoint is at 1500.
But how can I define allow arm disarm via tx yaw?
And after I connect the battery the lights stays flashing is this normal?
But how can I define allow arm disarm via tx yaw?
And after I connect the battery the lights stays flashing is this normal?
-
- Posts: 2
- Joined: Wed Jul 23, 2014 1:18 am
Re: motors dont run on multiwii quadcopter
U can defined it in config.h
No it's not normal to leds to flash more than 20secs at least
For my boards
Did u calibrate ::acc &mag
No it's not normal to leds to flash more than 20secs at least
For my boards
Did u calibrate ::acc &mag