Hi Guys,
I'm building my first quadcopter and I need help with the wirering.
I have Spektrum Dx6i with an AR6210 Receiver and a MultiWii Pro board and I dont know on which connectors i have to plug in the cables.
Please Help!
Thx
This is the receiver: http://www.hoelleinshop.com/hoellein/prodpic/Spektrum-Empfaenger-AR6210-6-Kanal-2-4GHz-DSM-X-SPMAR6210-HHSPMAR6210_b_1.JPG
Connecting MultiWii Pro to AR6210 Receiver
-
- Posts: 4
- Joined: Mon May 05, 2014 8:52 pm
Re: Connecting MultiWii Pro to AR6210 Receiver
THRO = Throttle
AILE = ROLL
ELEV = PITCH
RUDD = YAW
AUX1 = AUX1
GEAR = AUX2
Now just follow the wiring diagram for the MW FC board you have using 3 wire servo leads.
Check that each channel is working properly in MultiWiiConfig.exe.
Then Adjust the setting in the transmitter to obtain the correct directions, stick values at 1500 when centered and end point at 1000 & 2000.
AILE = ROLL
ELEV = PITCH
RUDD = YAW
AUX1 = AUX1
GEAR = AUX2
Now just follow the wiring diagram for the MW FC board you have using 3 wire servo leads.
Check that each channel is working properly in MultiWiiConfig.exe.
Then Adjust the setting in the transmitter to obtain the correct directions, stick values at 1500 when centered and end point at 1000 & 2000.
-
- Posts: 4
- Joined: Mon May 05, 2014 8:52 pm