Hello,
I'm working on a quad that flies via serial (XBee) control, but it's not quite working out. The is not much documentation out there regarding how to use MSP effectively, so I decided to make this topic as a place where people can post/look at code that works and transmitters/groundstations that work. If you have a UART Multiwii flying system please post some snippets showing how you send and/or receive data via MSP, and maybe a picture of your hardware setup.
Thanks, Matt
Flying with MSP successfully
- NikTheGreek
- Posts: 348
- Joined: Thu Dec 08, 2011 4:17 pm
- Location: Greece
- Contact:
Re: Flying with MSP successfully
Take a look here ...
http://www.multiwii.com/forum/viewtopic.php?f=8&t=3101&hilit=UART
it might help you..
http://www.multiwii.com/forum/viewtopic.php?f=8&t=3101&hilit=UART
it might help you..
Re: Flying with MSP successfully
Honestly that thread doesn't really answer all of the questions/problems I've encountered while getting my system working, but it does provide decent groundwork.
I'm gonna write a detailed instruction and post it somewhere, but if you need urgent help or have a question go ahead and message me. I have gotten off the ground on a serial data stream, with feedback from the quad, over an Xbee/MSP connection.
I'm gonna write a detailed instruction and post it somewhere, but if you need urgent help or have a question go ahead and message me. I have gotten off the ground on a serial data stream, with feedback from the quad, over an Xbee/MSP connection.