Ok so I am a bit of newbie to this whole multiwii thing and was hoping someone could help me…
I have a Multiwii 2.5 Board connected to a Futaba R2008SB Receiver and Futaba T8j Transmitter.
The two are binded as I have checked on a DJI unit I have here but when the reciever is plugged into the multiwii there is only a red flashing light.
Opening Multiwii GUI I can see all the settings for the copter the live view of the roll and pitch are working etc etc just there is no feedback for the
RX and TX..
I have reversed trottle and pitch as people mention and also increased all the end points to 125 on the hand unit, but still no love….
Hope this is enough info to get started
Futaba Multiwii not talking….
Re: Futaba Multiwii not talking….
Please post a picture how did you connect everything.
Re: Futaba Multiwii not talking….
Thanks for responding hopefully this will help..
https://www.dropbox.com/s/tfa3j0vm7u20fcp/photo.JPG
So I have
Multiwii: Futaba Reciever
• - Ch3
• + Ch3
• Throttle Ch3
• Alle Ch1
• Elev Ch2
• Rudd Ch4
• Gear Ch5
• Aux 2 Not Assigned
https://www.dropbox.com/s/tfa3j0vm7u20fcp/photo.JPG
So I have
Multiwii: Futaba Reciever
• - Ch3
• + Ch3
• Throttle Ch3
• Alle Ch1
• Elev Ch2
• Rudd Ch4
• Gear Ch5
• Aux 2 Not Assigned
Re: Futaba Multiwii not talking….
I hope someone has experience with this its sad not being able to get any responses from the TX RX
Re: Futaba Multiwii not talking….
Is the receiver getting power from the FC?
Re: Futaba Multiwii not talking….
Yep its getting power but nothing else, flashes red when connected to multiwii and I get solid green when its on the DJI Naza plugged into the SBUS single port..
Re: Futaba Multiwii not talking….
Do you have a small servo to plug into a receiver channel just to verify the receiver is outputting the correct PPM pulses?
Re: Futaba Multiwii not talking….
I have two receivers both had been binded to a dji phantom with no issues at all
Re: Futaba Multiwii not talking….
I've gotten a little bit further, supplier sent the arduino sketch I reloaded it and it all seemed fine when connected to USB.
As soon as I plugged the battery in its like it wipes the board or something?
Receiver goes back to flashing red and settings in multiwii GUI don't show
As soon as I plugged the battery in its like it wipes the board or something?
Receiver goes back to flashing red and settings in multiwii GUI don't show