evening all..
I have MW2.3 in a tricopter configuration on a HK 328p
i have the servo motor plugged into D3 on the 328P board. motors are in D9, D10, D11
My board arms just fine but I get no response from the servo motor for yaw inputs on the receiver or tilting the 328p board in my hand. I tried flashing 2.2 and i get the same behavior of no yaw action on the servo. All motors come up just fine.
I've calibrated ESCs, ACC & MAG so I'm not sure what else I can do..
Some questions come to mind which I hope somebody can help me with
1) do i need to power the servo with a seperate BEC/ESC? My servo is BMS-385DMAX Digital Servo
2) any way to test the servo using a connecting to the transmitter and the applicable config.h change? I'm wondering have I a dud servo
thanks
z
MW 328p & Yaw Servo
Re: MW 328p & Yaw Servo
to answer my own question, yes the multiwii can power the servo..(no separate ESC/BEC needed)
turns out i had a dud servo from hobbyking..replacing the servo with a new unit had the desired effect..
turns out i had a dud servo from hobbyking..replacing the servo with a new unit had the desired effect..