Page 1 of 1
Motor/Rotor Adapter
Posted: Fri Jun 22, 2012 6:26 pm
by awoods177
Hi all, the little metal bit that attaches the rotor to the motor broke and I have had a hard time finding a replacement part. I was wondering if these have a name I might be unaware of and if anyone has a recommendation on where to get them.
The original quad is here:
http://www.goodluckbuy.com/butterfly-x2 ... mbled.htmlIt was actually bought on eBay, but it's the same exact product.
Thanks,
Alex
Re: Motor/Rotor Adapter
Posted: Fri Jun 22, 2012 6:57 pm
by refractions
Depending on what your shaft diameter is you need the following:
http://www.goodluckbuy.com/4-mm-plane-fixed-pitch-propeller-adapter-shaft-bullet-typey-4-pack.htmlYou can get these on ebay and from most model shops.
Either measure the diameter of the motor shaft, or has your motors got a model number listed on them?
Iain
Re: Motor/Rotor Adapter
Posted: Fri Jun 22, 2012 8:27 pm
by awoods177
yeeees thank you!
Re: Motor/Rotor Adapter
Posted: Fri Jun 22, 2012 8:37 pm
by awoods177
Now, is the 4 mm the diameter of the motor shaft, or the diameter of the propeller shaft?
My motors are these: XXD 2200KV 1510 brushless motor
Just measuring inaccurately with a ruler I'd say they are approx 1.5 mm diameter.
My propellers are these:
http://www.goodluckbuy.com/gws-5030-503 ... -pack.htmlThey are approx 3 mm diameter.
Thanks,
Alex
Re: Motor/Rotor Adapter
Posted: Fri Jun 22, 2012 11:37 pm
by refractions
Re: Motor/Rotor Adapter
Posted: Fri Jun 22, 2012 11:40 pm
by refractions