Can't arm system
Posted: Fri Apr 06, 2012 12:51 pm
Hello
I have a quad based on the MultiWii Main Flight Control Board (http://www.drotek.fr/shop/en/51-multiwi ... mp085.html), 4 - Turnigy Plush 30A Escs and a HobbyKing HK-T6A V2 remote. My issues is I can't arm the system, everything else seems to work fine. When I connect the Drotek to the MultiWii GUI I nicely shows the changes in the signal, but these range from 1100 -1900, though i've boostes all channels to the max 120% interval. At some point I did "something" making it work, until I calibrated one of the esc that was a bit of (connecting the receiver directly to the esc giving a max min sequence), possibly also at the same time changing some other values of the system. After this I haven't gotten it to arm...
I'd grately appreciate any assistance.. I'm getting really frustrated, have been waiting for the parts for ages, and already manage to burn one set of Escs due to a short circuit and now this...
Best regards
Richard
ps. Just to be sure could someone clarify the arm sequence? I've understood its throttle min, yaw min, others middle. Though I've tried all kinds of combinations... This as I'm not 100% certain how to connect the channels to the remote. (it's now throttle + yaw and roll + pitch)
I have a quad based on the MultiWii Main Flight Control Board (http://www.drotek.fr/shop/en/51-multiwi ... mp085.html), 4 - Turnigy Plush 30A Escs and a HobbyKing HK-T6A V2 remote. My issues is I can't arm the system, everything else seems to work fine. When I connect the Drotek to the MultiWii GUI I nicely shows the changes in the signal, but these range from 1100 -1900, though i've boostes all channels to the max 120% interval. At some point I did "something" making it work, until I calibrated one of the esc that was a bit of (connecting the receiver directly to the esc giving a max min sequence), possibly also at the same time changing some other values of the system. After this I haven't gotten it to arm...
I'd grately appreciate any assistance.. I'm getting really frustrated, have been waiting for the parts for ages, and already manage to burn one set of Escs due to a short circuit and now this...
Best regards
Richard
ps. Just to be sure could someone clarify the arm sequence? I've understood its throttle min, yaw min, others middle. Though I've tried all kinds of combinations... This as I'm not 100% certain how to connect the channels to the remote. (it's now throttle + yaw and roll + pitch)