VTAIL configuration
Posted: Thu Jul 17, 2014 1:55 pm
Hi,
Currently I'm working on a 3Dprinted quad vtail.
I have read a lot on this forum about vtail frame configuration but it is still not 100% clear to me.
As I see a vtail can be made in 4 different ways. see image:
Is my image correct? Do the configs correspond to the vtail frame type?
Is it necessary to config other options?
Currently I'm working on a 3Dprinted quad vtail.
I have read a lot on this forum about vtail frame configuration but it is still not 100% clear to me.
As I see a vtail can be made in 4 different ways. see image:
Is my image correct? Do the configs correspond to the vtail frame type?
Is it necessary to config other options?