MultiWii

Hi.

Can I use the QuadX setup for a H4 frame, and do I need to do anything else ?

Thanks
/Jens

frame geometry is not important. What counts is where motors are located.

Okay !!!!!
So if my frame look like this, I can use the X-setup ?

O = motor

O O
\ /
\ I /
I
/ I \
/ \
O O

Oh my drawning don't work here.

I can ask in another way. What setup can be used for a frame like the QAV 500 ?

jjl wrote:I can ask in another way. What setup can be used for a frame like the QAV 500 ?

looks like a product name. So what does the producer/vendor say to your question?

I have not asked.
Some use Naza and others use CC3D, so I wonder if I can use MultiWii like I do on my Quad+ ?

Link to QAV500:
http://www.getfpv.com/multi-rotor-frame ... frame.html

/Jens

looks like average quad in x-config to me. Maybe not exactly 90 degrees all around, but give it a try and you shall find out.

Hi guys,

Hamburger, I think , like you, that the frame design doesn't matter at all in that configuration, because you have 4 motros so it's by definition a "quad".

What's important is if the flight controller board is perfectly in the center of the circle made by the 4 motors, so if you place the FC at this point exactly, configure a quad X and it'll work like a charm

Laurent