Plywood QUADX with HK MultiWii Pro FC

[modelci]

My first attempt at multicopter. I copied the frame HK site. I did CNC cut from 3mm birch plywood.
640mm distance between the motor axis. Empty weight was 230g.
I used on Hextronik DT700 Brushless Outrunners, HobbyKing 20A BlueSeries BSCs, two parallel 3S 2200 15C Zippy li-pos, 11x4,7 propellers.
Total flight weight is 1200g with HK MultiWii Pro FC and receiver.
I burned my gps came with the card during trials. Waiting for a new one.

I don't yet tried to blow outside. Only a few small trial in the home.

[NikTheGreek]

Good job
Looking good....

[modelci]

Thanks for your comment.

However, I decided to use Megapirateng software on this card with frame. I've installed, set up, tomorrow I'm gonna blow.

[modelci]

My first flight is not so bad.

http://youtu.be/H0ns1nfoYmc

[modelci]

And second flight:

http://youtu.be/2v24lfuBp5k

This frame is not very durable. I will change design.