Search found 154 matches
- Tue Sep 02, 2014 5:52 am
- Forum: Software development
- Topic: RSSI injection on RC channel
- Replies: 25
- Views: 7633
Re: RSSI injection on RC channel
sorry i missunderstood you, so the rssi is mixed in with an actual channel, like roll, or on its on channel like >4 that's correct, you can assign the RSSI to a specific channel (any channel >4 and available through rcData[] array). I'm not sure, but I was under the impression that EZUHF also offer...
- Tue Sep 02, 2014 3:16 am
- Forum: Software development
- Topic: RSSI injection on RC channel
- Replies: 25
- Views: 7633
Re: RSSI injection on RC channel
sure, kv/mw osd do this currently (have a look at their code), so its totally possible. though the pwm signal will be different between rc channel and rssi channel and likely different between receivers. Another option is a low pass filter (cap and resistor) I'm using OrangeRX UHF receiver with Ope...
- Mon Sep 01, 2014 10:38 pm
- Forum: Software development
- Topic: RSSI injection on RC channel
- Replies: 25
- Views: 7633
RSSI injection on RC channel
MWC doesn't appear to currently support handling RSSI as a PWM value from an RC input on a PPM channel... Is anyone working on this or has anyone tried doing it? It doesn't seem like a hard change to make, since the code just needs to be adjusted to take one of the channel values, scale it in the 0-...
- Thu May 01, 2014 12:34 pm
- Forum: Getting Started - MultiWii config and setup
- Topic: tricopter boom drops slowly
- Replies: 1
- Views: 665
tricopter boom drops slowly
im new to the multiwii and am trying to get an rcexplorer tricopter configured in acro mode. I'm having a problem with the left boom dipping very slowly and causing the tri to start rolling left after approx. 10 seconds. Ive tried adjusting rhe CoG and also adding some right roll trim to counteract ...