Search found 154 matches

by rubadub
Tue Sep 02, 2014 5:52 am
Forum: Software development
Topic: RSSI injection on RC channel
Replies: 25
Views: 2895

Re: RSSI injection on RC channel

sorry i missunderstood you, so the rssi is mixed in with an actual channel, like roll, or on its on channel like >4 that's correct, you can assign the RSSI to a specific channel (any channel >4 and available through rcData[] array). I'm not sure, but I was under the impression that EZUHF also offer...
by rubadub
Tue Sep 02, 2014 3:16 am
Forum: Software development
Topic: RSSI injection on RC channel
Replies: 25
Views: 2895

Re: RSSI injection on RC channel

sure, kv/mw osd do this currently (have a look at their code), so its totally possible. though the pwm signal will be different between rc channel and rssi channel and likely different between receivers. Another option is a low pass filter (cap and resistor) I'm using OrangeRX UHF receiver with Ope...
by rubadub
Mon Sep 01, 2014 10:38 pm
Forum: Software development
Topic: RSSI injection on RC channel
Replies: 25
Views: 2895

RSSI injection on RC channel

MWC doesn't appear to currently support handling RSSI as a PWM value from an RC input on a PPM channel... Is anyone working on this or has anyone tried doing it? It doesn't seem like a hard change to make, since the code just needs to be adjusted to take one of the channel values, scale it in the 0-...
by rubadub
Thu May 01, 2014 12:34 pm
Forum: Getting Started - MultiWii config and setup
Topic: tricopter boom drops slowly
Replies: 1
Views: 162

tricopter boom drops slowly

im new to the multiwii and am trying to get an rcexplorer tricopter configured in acro mode. I'm having a problem with the left boom dipping very slowly and causing the tri to start rolling left after approx. 10 seconds. Ive tried adjusting rhe CoG and also adding some right roll trim to counteract ...