MultiWii

Hi, I had some issues with my internal compass (drifted during throttle up). My small copter had no more possibilites in ordering the components in another way, so I unsoldered the internal HMC5883L from the FLIP32+ and hooked up the external compass of my GPS/Mag Combo Board (CJMCU-108 / UBLOX NEO-...

Hi!
Is there a way to access the sat count value via frsky telemetry?
Which variable should i use in my lua script (taranis)

Would be great if anybody could help.

Hi, I have nearly everything up running. Only the current will not show up. the accumulated current is counting up and the vbat is shown correctly, but the currently used amps are always at 0.0mAh. Here is a "schematic" of my setup (I still have to tweak the powermeter settings): http://3....

You can try to delete the eeprom and flash multiwii again.
In arduino IDE load the example -> clear eeprom.

Regarding RSSI, the FrSKY offers RSSI on pin2 as PWM. Do i have to filter it out through R-C filter or it accepts PWM directly? Found a tool to calculate RC filter here m OK. That is the reason why i get strange values for the rssi with my frsky. Tranmitter on rssi = 0 transmitter off rssi = ~90 ED...

The Icon in Thema middle stands for rssi.
Unfortunatly i dont know how Tor disable it. Perhaps in the osd configuration menu?

You are absolutely right! MY FAILURE. I flashed a 328 before and have forgotten to switch back to MEGA.

Many thanks for your help!!

The board selection is correct. I have a crius AIO board.

Thanks, so I am not the only one

Hi, I have got a strange problem in the newest dev (r1317): As soon as I activate one of the following cam stabilizations: //#define SERVO_MIX_TILT //#define SERVO_TILT I get this error message during the compile process: Output:623: error: 'PORTL' was not declared in this scope with both options co...

Hi,
is there a way to connect an external current sensor to the MinimOSD?
Perhaps through a free Atmega-Pin (Miso,Mosi)?

I have got a working BTM-222 with robotrack-pcb.

Is there any Android-compatible software, which can change f.e. the PID-settings of my MultiWiiCopter?
That would be awesome on the flying field!

Heres another ITG3205-WMP layout and the corresponding SCL+SDA Points:

I am experiencing the same. Without NK attached and 100khz the values are looking good (3000 cycletime).
I ordered already a BMA020 in order to replace the NK.

Will this problem be solved with the BMA?

Perhaps the HobbyKing-Frame is something for you:
http://hobbycity.com/hobbyking/store/uh_viewItem.asp?idproduct=16583
15 USD

Thats exactly the wmp I meant.

My problem is, that the curves are going above the white area in the gui.
After hitting reset on the arduino the curves are much lower and not so over-sensitive.

At first: Congrats for this really great project. I read some posts about support for the ITG3205 is in development. Will this WM+ be supported? I tried to solder it to my shield, but the graphics in the Config-Tool went really rollercoasterlike. In the current version of http://code.google.com/p/mu...