MultiWii

Perfect!

dongs wrote:You need to install 64bit version of Java. (ugh).

I have it, I use this machine for everything I do.

I can't get the 64 bit Windows version of conf to run. 32 bit starts fine but even trying to run the 64 bit version as administrator does nothing (I do say yes to the UAC prompt) . No errors in the event viewer, nothing in task manager.

I did, that works fine. I can't get the dev GUI to show gyro or NK data.

If I use Arduino .23 to load the 1.9 sketch, and then use the 1.9 GUI all is well. If I load the dev sketch using Arduino 1.0, then the dev GUI I can see the stick movements but no gyro or NK data. Been back and forth too many times to count.

OK, I tried the 1.9 sketch and gui and I see the data properly there. If I use Arduino 1.0 and the dev version of MultiWii I get no gyro data.

OK, so I have header pins connecting them now. When I run the gui with just the Arduino board and the WMP connected should I see changes when I move the motion plus around? I hate to ask these stupid questions but I haven't found a quick start guide anywhere. It's funny, I make my living managing a ...

I have all pro mini edge pins connected. Where are a4 and a5?

never mind, I see it now.

I have it connected per this diagram.

I hate to ask total no0b questions but I have searched high and low and there is simply too much data to do a proper search. I think I may have a bad WMP. With just the Arduino and WMP connected should I see gyro data when I move the board around? I uploaded the sketch, and see RX data in the GUI. I...

Never mind, I found the orientation here,

http://www.multiwiicopter.com/pages/multiwiicopter-wiki

On a side note, why is the sketch a .ino file in the dev version?

I tried the dev version on 1.0 and it failed too.

Ok, I have 2 of the Pro Mini's and they both had header pins soldered to them. I was trying to upload the 1.9 sketch with the Arduino .23 app on Windows 7. Both were failing with this error, avrdude: stk500_getsync(): not in sync: resp=0x00 avrdude: stk500_disable(): protocol error, expect=0x14, res...