MultiWii

yes. its the same behavior like me...
Jan

Yes i have loaded the map.
If i reload the original SW by johnny (the beta9) it looks ok. Only that i get no datas from the FC because of the new serial protocol of the 2.11. But the Display looks good. All things are on the right place. And with the new soft... I see only crap No idea.
Jan

Hi kataventos,
i think i will give up. I loaded the 2.11 1240 on my FC and your 1.01 in the OSD. It doesnt work. No chance. I see only the horizon. Do you have really an original Rushduino Board V1.2? I dont understand where there a problem is...

Jan

Hi kataventos,

thats the result with the unchanged MTK version:



Jan

Hi, i give it up for the moment. I reload the .mcm file (Rushduino OSD CC rev Bledi 7.mcm). Then I flashed the Alfa5 version in my OSD. the result was this: http://www.home42.de/staroman/osd2.jpg Nothing works... With the last "official" Rushduino OSD i get the datas from the analog sensor...

original means that which came with the board. i never changed it...
Jan

no changes. tried also the MTK version. same result. I have the original .MCM on it.
Jan

Hi kataventos, I can not imagine thats the problem. because I also dont see the current and the voltage. Even if i dont connect the OSD to the serial of the FC. So in my opinion, if the SW works and the OSD has power it has to display the current and the voltage(from the currentsensor...). Something...

Hi,
i dont know. I tried both versions (trailblazer and kataventos) on my Rushduino. It dosnt work with my 2.11 dev1232. I hav only the horizon... Nothing else. Any ideas whats my fault?
cu Jan

Has anyone a sw version for the rushduino working with the devs?
Jan

Hi,
no i tried the other code for your diy board and changed the things what you wrote. With the MW 2.1 the original Rushduino SW works. But the dev changed something in the serial protocol. So i hoped you sw will work...
Jan

Hi,
tried the Modelci code on my Rushduino 1.2 . It doesnt work . Made the changes how described. Fly with 2.11 dev 1177 ... Any hints?
Jan

Hi,
the current sensor works now. The software isnt finished at this point. Also the current consumption isnt ready. I tried it but not succsesfully. Has anyone the correct code for displaying the current consumption?
Jan

Hi,
yes this looks good. Will try it soon.
But another question. The OSD shows negative current datas. Can I calibrate this via the calibration factor? Also how i can setup the offset of my current sensor i dont really understand.
Jan

ok,
i tried the serieal port 0( ftdi). and it works. but how can i configure the serial output to serial3 on my mega board?
Jan

Hi, I have a big problem with my OSD. HW is Flyduino Mega Multiwii 2.1, Rushduino V1.2 beta07 V9. It seems that the OSD receive no data from the Multiwii. I have no horizont and the other Wii related things. Only the voltage and the current is displayed. I have activated in the multiwii config.h the...