MultiWii

I'm running Multiwii se 2.5 on a multiwii 2.5 on my quadcopter. ESCS are properly connected and calibrated, wiring has been checked and heat shrinked, accelerometer and mag calibrated. Below is the link to the board I'm using specifically: m I have no issue arming it with my receiver, but when I try...

Fixed them to get them as close as I can to 1500. Still no luck. Even switched to Acro as I've read it's a bit simpler, and still nothing. Here's a new video showing the tendency for it to lift higher on one side first: m you can skip to second 12. Thought it would help to log the details of the mic...

I'm working on a quadcopter, specifically this one: http://www.multiwii.com/forum/viewtopic.php?f=18&t=7344 I was having trouble arming it before, and now after setting my endpoints as suggested I am able to arm it with the yaw without issue making mincommand 1000 and maxthrottle 2000. However w...

I was able to partially solve this issue in that I restored the ESCs to factory settings using the following manual:

https://hobbyking.com/media/file/811103388X7478X20.pdf

However I am still curious about the automatic ESC calibration. If anyone has any ideas do let me know thank you

Setup a Multiwii 2.6 quadcopter system and I want to now calibrate the range of throttle on the 30A UBEC hobbyking escs. Following the instructions in this video: m I attempted to change the throttle range but it doesn't seem to be working. I'm wondering if perhaps I am not doing something incorrect...

Hey Guys, I'm working on building my first quadcopter. Below are the primary parts I am using: 1. CRIUS Multiwii se v2.5 chip 2. 4 Hobby King 30A ESC 3A UBEC 3. Turnigy D3530/14 1100KV Brushless Outrunner Motor (already checked the motor direction to make sure they spin the right way) 4. Turnigy 9X ...

I gave it a try on windows and still got a failure. Used Arduino IDE 1.0.1 and I got the longest wait time during "uploading" but then i got stk500_v2_getsync(): timout communicating with partner. I did get a "done uploading" sign, but with all the timeouts. Is it possible that t...

I may have to try that. I've tried three versions of Arduino and still nothing. I believe the com ports are right. I checked the macbook's USB SERIAL port number. I will retry it on windows later today as I am more confident of the USB drivers being installed on that computer. Might this issue be re...

Thanks so looked through the specs and I'm assuming you are referring to the following two specs: ATMega 2560-16AU Microcontroller MPU6050 6 axis gyro/accel with Motion Processing Unit So I changed the board on IDE to Atmega 2560 and got the following message: avrdude: stk500v2_ReceiveMessage(): tim...

Hey Leo, Appreciate the quick response!! So this morning I went ahead and plugged in the CRIUS AIO, (at work so I'm using my mac) and I'm still getting some issues, hopefully y'all can shed some light. http://i1205.photobucket.com/albums/bb437/fauslyfox110/IMG_20160105_094655.jpg I've been relying o...

Hello all, I'm working on my first drone and chose a crius all in one pro v 2.0. I'm looking to flash multiwii 2.5 and I've downloaded all the software and attempted an upload via an ftdi cable I had. I haven't connected any of the escs or anything other than the ftdi cable. I'm having some issues w...