Search found 4 matches
- Fri Jun 12, 2015 2:03 pm
- Forum: Software development
- Topic: Atmega328 with fet output for motor brushed
- Replies: 39
- Views: 23751
Re: Atmega328 with fet output for motor brushed
i´m a little confused. is it possible to run 6 brushed motors on 328? if yes, would someone share his mwii sketch? i have build a nano spider hex with a pro mini I'm also confused and would like to know too My project is to use a Mini MWC board (328p from HK with DSM rx) to control the built-in bru...
- Thu May 07, 2015 3:52 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1378503
Re: Naze32 hardware discussion thread
Hi there, could be nothing but I suspect something s wrong with my Naze32 full. When I connect it on the USB and check Baseflight, the gyros act up and do not return any positionning data on Baseflight. Then after a couple of minutes, the model reacts on the setup page but still don't show a proper ...
- Sun Apr 26, 2015 12:31 am
- Forum: Frames
- Topic: Nanocopter Frames
- Replies: 111
- Views: 374517
Re: Nanocopter Frames
Thanks for the answer. The Hexatron is actually a brushed Hex running under 2S so the Mini WMC should be good. Now that I know it's doable the funny part is to find where to bypass the original FC to only use its ESCs
- Thu Apr 23, 2015 11:26 am
- Forum: Frames
- Topic: Nanocopter Frames
- Replies: 111
- Views: 374517
Re: Nanocopter Frames
Bravo, very nice successfull project! I don't mean to hijack your thread but after reading it you seem to have the answers I'm looking for To make it short, I received a Revell Hexatron (brushed, 2S, builtin ESC) as a gift and the thing flies like whale with the bundled TX. So I was thinking about s...