MultiWii

Hi waltr, always thank you for the guide lines. As i go thru I find MSP_SET_MOTOR and MSP_SET_RAW_RC useful for me but I am not sure where should I write this code into so that I can use only FTDI cable for sending signals to control motor from computer, I find many tabs when I open the source code ...

Can we import the sensors information of MultiWii into the matlab using FTDI cable? , and Can we control the rotors connected to MultiWii using only FTDI cable for sending control signal directly from Matlab? Are there possibilities of doing so.

Hello guys: I have some error problem. while I upload the code to multiwii SE it shows following error

avrdude: stk500_getsync(): not in sync: resp=0x30

what does it mean and how can I overcome this?

Thanks in advance.

Thank you waltr.

Can we send the control signal to multiwii from computer via USB-FTDI interface instead of using wireless receiver?