MultiWii

mr.rc-cam et al: GREAT JOB! Wow you guys have spent alot of time energy, and grey cells trying to fix this problem! Thanks! Is there a patch "file" or do i just cut and paste from above into the config file and recompile? Or should i just wait for the next update? I went from 1.7 to 1.8p2 ...

BMP085 Baro on the Quadrino board:
http://www.declspec.com/quadrino-datasheet.pdf

Thanks guys! I didn't see the manual, didn't come with my pre-built Quadrino (Witespy). I don't have it completely boxed, but have a plastic dome over it. I had read somewhere (here?) that the sensor was sensitive to light so I put a small piece of open cell foam over it. Zero wind this morning so I...

I have a Quadrino with baro and mag. (HMC5883 Mag and BMP085 Baro) The Acro mode works great, & the level mode works well. BUT: When I active the Level hold my Quad accelerates up about 20-30 ft and then heads toward the ground very fast. I, of course, switch back to acro and gain control. My Qu...

Mr rc-cam: THANKS! Now that I know where to look, I can find them in the future (teach a man to fish.....) I used the Ardino and uploaded the compiled file to the board, but didn't ever see those values? Don't know where I went wrong but I've got it now! Re Baro: I did find out I didn't tilt through...

zviratko: Thanks, but i hate to clear and start again. I just got it really dialed in, so I must be close. I'm just having a lot of trouble with Baro and Mag.

I have downloaded the Patch 2 ver of 1.8 three times on two different computers. The default PID values are always Zero (0). I was told the defaults should load but couldn't figure out why they are not. I just copied my PIDs from 1.7 BUT apparently the defaults for 1.8p2 are different. Can some plea...

I'm just getting things up and running. I've flown a few times, but have no idea
if i need to change anything specifically for my ESC. Or what to change them too?
Thanks,
Gary