MultiWii

So I just had a couple of flight tests of my freshly-built "FPV250v3" frame with a NAZE32 at it's center. It's 572gm AUW. I am using 5030 2-blade gemfan props, Sunnysky X2204S 2300kv motors, 12amp SimonK ESCs, and a 1600mah 3S lipo. I am finding that it is really quite sluggish to respond ...

Viewing from the rear of the quad. Esc output 1 to closest right land side motor Esc output 2 to furthest right hand motor Esc output 3 to nearest left hand motor Esc output 4 to furthest away left hand motor. It is simplicity itself provided you have your esc's labeled properly and your esc's are ...

It sounds to me like you have your escs plugged into the wrong pins. If you dont think this is the mixup an easy fix would be to plug the front left motor which should be 4 to the pin that outputs when you test motor 4, and the same with the rest. And when you are done you have discovered the right...

yea, pretty sure motor test just outputs in normal order. While mixer is different. If it wasn't for years of retarded backwards compatibility, i'd say we should change mixer to use normal CW or CCW motor indexing without the dumb multiwii order. But too late now. Well the good part is that at leas...

I am setting up my first NAZE32. I have the board installed on my quad, and powered up via the receiver. I have it plugged into the configurator. Everything seems to be going fine but I have discovered what appears to be a discrepancy in the way the app identifies the motors. Here is the diagram I a...