Search found 6 matches
- Fri Nov 07, 2014 9:32 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1431140
Re: Naze32 hardware discussion thread
Hi. I have a naze32 flashed with the latest firmware # version Afro32 CLI version 2.3 Oct 1 2014 / 07:45:46 If I power the board through usb, or a bec, and then power up my escs, all is well and everything works. HOWEVER. If I power the board and escs simultaneously, I only get the startup tone fro...
- Mon Oct 13, 2014 5:45 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1431140
Re: Naze32 hardware discussion thread
It sounds to me like you have your escs plugged into the wrong pins. If you dont think this is the mixup an easy fix would be to plug the front left motor which should be 4 to the pin that outputs when you test motor 4, and the same with the rest. And when you are done you have discovered the right ...
- Mon Oct 13, 2014 6:41 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1431140
Re: Naze32 hardware discussion thread
If it makes a difference (which I don't think it should, since this doesn't happen with the acro version), the escs are cheap cheap hobbywing 30amp copies from china with linear BECs and original firmware, there doesn't seem to be any delay in 5V out, though.
- Mon Oct 13, 2014 4:59 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1431140
Re: Naze32 hardware discussion thread
yeah i did the full chip erase, I have no clue. It's really weird it works perfect when the fc is powered up, then everything else. I registered here just to post, in all of doing this stuff I've been able to figure everything out, and this makes no sense at all to me. I've gone over it and over it ...
- Mon Oct 13, 2014 4:23 am
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1431140
Re: Naze32 hardware discussion thread
timecop, do you have any thoughts on my issue a couple posts back about no pwm output on powerup? I have searched for the answer, but turned up nothing on these overloaded threads.
- Sun Oct 12, 2014 11:10 pm
- Forum: Boards
- Topic: Naze32 hardware discussion thread
- Replies: 3249
- Views: 1431140
Re: Naze32 hardware discussion thread
Hi. I have a naze32 flashed with the latest firmware # version Afro32 CLI version 2.3 Oct 1 2014 / 07:45:46 If I power the board through usb, or a bec, and then power up my escs, all is well and everything works. HOWEVER. If I power the board and escs simultaneously, I only get the startup tone from...